Pcm-5821 And I/O Adapter Replacement; Figure 2-4: Installing/Removing The Pcm-5821 And I/O Adapter - Advantech PPC-105 User Manual

Table of Contents

2.7 PCM-5821 and I/O Adapter Replacement

To replace or service the PCM-5821 (the all-in-one CPU board) and I/O

adapter, complete the following steps:

1. Turn off the power to the PPC-105

2. Remove the rear protective cover (see Figure 2-1)

3. Install the PCM-5821 in the panel and screw in the eight screws (see

Figure 2-4)

4. When the PCM-5821 is mounted in the panel, plug and press the

adapter into the socket (see Figure 2-4))

5. Some screws on your left hand side connect the I/O adapter to the

PC, and also connect the adapter to the PCM-5821. Screw the screws

into the panel.

Note:

You may change the jumper settings for RS-232/422/

485 before installing the PCM-5821 and I/O adapter

in the PPC-105

Chapter 2 System Setup

Table of Contents