Advertisement
Several times, tip down the equipment with
rotating nylon head onto covered ground. This
dispenses nylon line in steps. Per release, approx. 30
mm line length will be dispensed. Excess line
5.4 Troubleshooting
Fault
Motor will not start
The cutter does not rotate,
even though the motor is
running.
Cutting line will not unreel
Electric brushcutter
Motor type / Motor power
Mains voltage / frequency
Protection class
Extension cable (accessory)
Rated speed of the cutter
Drive shaft – property / diameter
Shaft tube – material / diameter
Standard cutting tool
Cutting diameter
Dimensions - Height / Width / Length
Weight w/o guard and cutting tool
Weighted effective acceleration (EN 786 Appendix D)
Handle r.h. side / handle l.h. side
Sound pressure level LP
Sound power level L
actual / guaranteed 95%
/
Possible cause
1. No power supply
2. Cutting tool
jammed/blocked
1. Flexible shaft broken
2. Flexible shaft incorrectly
assembled
1. Line spent
2. Line reel jammed, line
twisted
(EN 786 Appendix E) dB(A)
eg
(EN 786 Appendix E)
Weg
lengths will be trimmed to size by the line trimming
blade.
1a.Check the mains supply and the extension cable.
1b. Check the mains socket (e. g. different
equipment plugged in).
2. Pull the mains plug and clear the cutting tool.
1. Contact your local specialist.
2. Contact your local specialist.
1. Pull the mains plug and load a new cutting line.
2. Pull the mains plug, open the nylon head,
rewind the line, clean the reel and re-assemble
correctly.
6. Specification
W
Electric motor / 700
V / Hz
1
/
7000-8000
min
mm
Ø mm
Steel / 25
2-line nylon head; semi-automatic;
square section and twisted line Ø 2.0 mm
Ø mm
cm
kg
2
6,16 / 4,32
m/s
dB(A)
95,40 / 96
Using your brushcutter ; Specification
Remedy
113
Electric motor / 850
230 AC / 50
II (double-insulated)
DIN 57282/H07 RN-F
Flexible / 6,2
370
149 / 49 / 35
4,6
75,8
114
7000-8000
Aluminium / 25
4,6
6,07 / 6,18
76,6
95,48 / 96
ENGLISH
9
Advertisement
