Set Area; Clear Area; Disable Function; Tempering Alarm - Kedacom IPC Series User Manual

4.2.1

Set Area

Motion detection supports full area detection and maximum 4 user-defined areas.
Go to Settings>Event>Video Analysis>Motion Detection, check "Enable".
1)
Click "Edit" and the image will be divided into 16 columns and 12 rows of squares.
2)
Click a square and drag an area from it, then the area will turn purple and is the
motion detection area. A camera can support maximum 4 areas.
3) Drag the slide bar to adjust Sensitivity.
Click "Edit". On the popup page, check durations and set start time and end time.
4)
Click "Copy" to copy the defined motion detection time to a certain day or the whole
5)
week.
Select "Linkage Type". It is the alarm output method when an alarm is detected in
6)
the defined area.
4.2.2

Clear Area

Start from an undefined square and draw an area that contains the defined area, or
click the defined squares one by one to clear setting, or click "Clear" to clear setting.
Save to make settings effective.
4.2.3

Disable Function

To disable this function, uncheck the checkbox

4.3 Tempering Alarm

Go to Settings>Event>Video Analysis>Tempering Alarm. Please refer to 4.2 Motion
Detection.
Picture 4-3 Motion Detection
Enable.
13