Table of Contents
Advertisement
Loosen nuts then lift vehicle. Place a
support under vehicle. Remove nuts
then remove wheel. At installation, it
is recommended to apply an anti-seize
lubricant on threads. Gently tighten
nuts in a criss-cross sequence then ap-
ply a final torque of 53 N•m (39 lbf•ft).
CAUTION:
Always use the recom-
mended wheel nuts (P/N 732 610
084). Using a different nut could
cause damages to the rim.
Front Wheel Bearing Condition
Push and pull the wheels from the
upper edge to feel the play. See an
authorized Bombardier ATV dealer if
there is any play.
Rear Axle Inspection
Lift rear of vehicle high enough to
have wheels off the ground. Push
and pull rear axle to feel the play. See
an authorized Bombardier ATV dealer
if there is any play.
SteeringSystem
Throttle Cable Lubrication
The throttle cable must be lubri-
cated with Bombardier cable lubricant
(P/N 293 600 041) or an equivalent.
WARNING
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable stick-
ing or stiffness.
Open the throttle lever.
V01I0ZY
1. Remove screws
Remove:
– the cable from the throttle lever
V01I10Y
1. Throttle handle housing
2. Throttle cable
NOTE:
move the end of cable from clip.
– the seal on the throttle cable.
V00I02Y
Remove the carburetor side cover.
Install the cable luber (P/N 529 035
738) or an equivalent on the cable.
_____________________
1
2
Slide cable in clip slot and re-
1
99
Hide quick links:
Advertisement
Table of Contents
