Checking And Replacing The Chain Sprocket - Stihl HTA 65 Instruction Manual

Storing the Battery
Take the battery out of the power
N
tool or the charger.
Store indoors in a dry and safe
N
location. Keep out of the reach of
children and other unauthorized
persons and protected from
contamination.
Do not store spare batteries unused
N
– use in rotation.
To optimize the life of the battery, store
it at a state of charge of about 30%.
Storing the Charger
Remove the battery.
N
Disconnect the plug from the wall
N
outlet.
Store the charger indoors in a dry
N
and secure location. Keep out of the
reach of children and other
unauthorized persons and
protected from contamination.
HTA 65, HTA 85
Checking and Replacing the
Chain Sprocket
Move the retaining latch to ƒ.
N
Remove the battery.
N
Remove the chain sprocket cover,
N
chain and guide bar.
Replace the chain sprocket:
N
a
after using two saw chains;
–
or sooner if the wear marks (a) on
–
the sprocket are deeper than
approx. 0.5 mm (0.020 in) since this
would reduce the life of the chain.
You can use a gauge (special
accessory) to check the depth of the
wear marks.
It is best to use two saw chains in
rotation with one sprocket.
2
1
Use a screwdriver to remove the E-
N
clip (1).
Pull off the chain sprocket (2).
N
2
1
Push the new sprocket (2) on as far
N
as stop.
Fit the E-clip (1).
N
English
31