Injector - Removal And Installation - MTU 12 V 2000 M92 Operating Instructions Manual

Table of Contents

Advertisement

7.6.2 Injector – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Socket wrench
Puller
Double box wrench
Open end wrench bit
Box wrench adapter
Alignment device
Grease (Kluthe Hakuform 30-10/Emulgier)
Engine oil
WARNING
Fuels are combustible.
Risk of fire and explosion!
• Avoid open flames, electrical sparks and ignition sources.
• Do not smoke.
Preparatory steps
1.
Close fuel supply to engine.
2.
Remove cylinder head cover (→ Page 76).
Removing injector
1.
Remove HP line (5) using socket wrench.
2.
Disconnect injector cable (4).
3.
Remove screw (2).
4.
Take off hold-down clamp (3).
5.
Remove injector (1) with puller.
6.
Remove O-rings from injector.
7.
Mask all connections and bores or seal with
suitable plugs.
78 | Task Description | M015700/06E 2012-06
Part No.
Qty.
0005896803/00
F6790629
F30011450
F30025897
F30451199
F6790507
X00029933
1
1
1
1
1
1
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

16 v 2000 m92

Table of Contents