Table of Contents
Advertisement
REMOTE CONTROL
Signal
transmission point
Power ON / OFF
button
Fan speed
adjust button
Timer on / off
button
Preparation efore peration
B
Remove the battery cover and insert new
batteries (AAA), making sure the + and -
match the compartment markings (Fig
During Operation
If the remote control will not operate the air
conditioner, the batteries may need to be
replaced.
Remove the batteries and replace with new
ones. If this does not solve the problem
contact your nearest service centre for
advice.
Note! The air conditioner must be plugged in
and switched on for the remote control to
operate the air conditioner. To use, point at
the signal receiving window on the front
panel and press the remote button (Figure
8). The air conditioner will "beep" when a
signal has been received. If there is no beep,
press the remote button again, ensuring it is
within range (6 metres) of the air conditioner.
NOTE:
!
WASTE BATTERIES SHOULD
BE DISPOSED OF CORRECTLY
6
CP15HW1 Portable Reverse Cycle Air Conditioner
9
Temperature /Timer
adjust buttons
Mode buttons
(Cool Dehumidify-Fan
-
O
10
).
-Heating
)
If there are two of the same air
conditioners installed, they cannot be
controlled separately. When you operate
either remote, it will turn on both air
conditioners if they are both within signal
range (6 metres).
Care of your emote ontrol
R
Don't let the remote control drop onto
hard surfaces or be subjected to sudden
shocks
of
any
form
not cover misuse or accidental damage.
Don't place the remote control in direct
sunlight, or near extremes of temperature.
Don't allow the remote control to get wet.
Don't place near strong electromagnetic
waves.
Don't mix old and new batteries!
If the remote control will not be used for a
long time, remove the batteries to avoid
corrosion.
10
Battery
compartment
Battery cover
C
. The warranty does
Advertisement
Table of Contents
