Remote Control - Seeley Climate Master CM12W Owner's Manual

REMOTE CONTROL

Signal
transmission point
Fan speed
adjust buttons
Temperature
adjust buttons
Sleep mode button
Ion / TiO button
2
(only active for
models CM12WX
and CM15WX)
Preparation before operation
Remove the battery cover and insert new
batteries (AAA), making sure the + and - are
matching the compartment markings (Fig
10) .
During Operation
If the remote control will not operate the air
conditioner, the batteries may need to be
replaced.
Remove the batteries and replace with new
ones. If this does not solve the problem
contact your nearest service centre for
advice.
Note! The air conditioner must be plugged in
and switched on for the remote control to
operate the air conditioner. To use, point at
the signal receiving window on the front
panel and press the remote button. The air
conditioner will "beep" when a signal has
been received. If there is no beep, press the
remote button again, ensuring it is within
range (6 metres) of the air conditioner.
NOTE:
!
WASTE BATTERIES SHOULD
BE DISPOSED OF CORRECTLY
6
9
Mode buttons
(Cool-Dehumidify-
Fan-Heat)
Timer on / adjust
button
Power ON / OFF
button
®
ClimateMaster series Portable Refrigerated Air Conditioner
If there are two of the same air
conditioners installed, they cannot be
controlled separately. When you operate
either remote, it will turn on both air
conditioners if they are both within signal
range (6 metres).
Care of your remote control
Don't let the remote control drop onto
hard surfaces or be subjected to sudden
shocks in any way. The warranty does not
cover misuse or accidental damage.
Don't place the remote control in direct
sunlight, or near extremes of temperature.
This will affect the control's temperature
reading.
Don't allow the remote control to get wet.
Don't place near strong electromagnetic
waves.
Don't mix old and new batteries ! If the
remote control will not be used for a long
time, remove the batteries to avoid
corrosion.
10
Battery
compartment
Battery cover