Install Ation - Seeley CP15HW1 Owner's Manual

INSTALLING THE EXHAUST HOSE
Step 1: Push the Hose End onto the cooler,
and rotate so the slot locks onto the catch
(Fig 5). F it the exhaust hose to the
End and Hose Exhaust Nozzle by turning
clockwise.
Step 2: Open a indow and fit the Window w
K it. Extend the attachment as required and
lock into place with the w
Ensure the outlet is not obscured. The
Window K can be installed horizontally or it
vertically, t o suit your
Exhaust Nozzle to the Window Kit, and lock
into place (Fig 7A & 7B ).
INSTALLING THE DRAIN PUMP HOSE
Step 1. Connect the Drain Pump Connector
to the drain hole on the rear panel (Fig 6).
Push firmly to lock into place.
Step 2. Connect the supplied water hose to
the Drain Pump Connector (Fig 6).
Step 3. Lead the other end of the hose
through the hole in the Window Kit to the
outside or to a suitable location for drainage
i.e. a drain or sink.
4 CP15HW1 Portable Reverse Cycle Air Conditioner
Hose
s
ingnuts provided.
window type. Fit the
5
6
Note! The minimum distance required
from the operating air conditioner to
any obstructing objects or walls is
50cm.
Keep the exhaust hose as short and
straight as possible and minimise
kinks. This will maximise the cooling
performance.
Don't use extension pieces for the
exhaust pipe as this will reduce
performance and possibly result in
damage to the air conditioner.
Hot air and possibly mist will be
emitted from the exhaust hose.
Note! It is critical to the performance of
the unit that the hot exhaust air is
completely removed from the space
being cooled.
7A
7B