Remote Control - Seeley convair CP35CW1 Owner's Manual

REMOTE CONTROL

Preparation Before Operation
The remote comes with a battery already
installed.
Remove the transparent strip as shown to
power up the remote (Fig. 9).
|
6
9
10
CP35CW1
Battery Replacement
Remove the cover on the rear of the
remote control by pushing the latch and
pulling on the cover (Fig 10.).
Remove the battery and replace with
type CR2025. Ensure that the polarity is
correct when inserting the new battery.
Note! The air conditioner must be
plugged in and switched on for the remote
control to operate the air conditioner. To
use, point at the front panel and press the
remote button.
Note! If there are two of the same air
conditioners installed, they cannot be
controlled separately. When you use a
remote, it will operate all air conditioners
within signal range
Care of your Remote Control
Don't let the remote control drop onto
hard surfaces or be subjected to sudden
shocks of any form. The warranty does
not cover misuse or accidental damage.
Don't place the remote control in direct
sunlight, or near extremes of temperature.
Don't allow the remote control to get wet.
Don't place near strong electromagnetic
waves.
If the remote control will not be used for
a long time, remove the battery to avoid
corrosion.