Wiring Descriptions - Ultra Start 25 series Install Manual

INSTALL MANUAL
PAGE 8

Wiring Descriptions

MAIN CONNECTOR (6pin)
Pin
1-YELLOW Starter Output -
2-GREEN Heater/Acc Output -
3-RED 12volt Input(30amp) -
4-RED 12volt Input(30amp) -
5-BLUE Ignition Output -
6-WHITE Selectable Output -
AUXILIARY CONNECTOR (14pin)
Pin
1-YELLOW Re-arm(-) -
2-ORANGE Anti-Grind/ (-) -
Starter Kill
3-BROWN Dis-arm(-) -
4-RED/ Trunk Release(-) -
WHITE
5-WHITE/ Ground While Running(-) -
VIOLET
6-GREEN Door Pin(-) -
7-GREEN/ Hood Pin(-) -
WHITE
8-PURPLE Door Pin(+) -
9-PINK Brake Light (+) -
10-BLACK Ground(-) -
11-BLUE/ Tach(A/C)
WHITE
12-BLUE Diesel(+/-)
Function
This wire will test 0V in OFF, ACCESSORY and in the
ON key positions. 12v during START ONLY.
This wire will test 0V in the OFF and ACCESSORY
key positions.12V in the IGNITION and START.
Function
0.75 second pulse output when
remote start shutdown. Used for factory alarm re-arm.(menu 3)
Output active during remote start. Programmable Starter
Kill output. (Menu 3)
0.75 second pulse when
starter activation. Used for factory alarm dis-arm. (Menu 3)
Programmable output. Hold
output will stay active (max 5 seconds) or (-)park light.
Input to detect (-) when door is open.
Input to detect ground when hood is open.
MUST BE CONNECTED.
Input to detect 12v when door is open.
Positive brake light switch input. Used to detect the
brake switch being applied.
System chassis ground input.
- A/C Tach signal input. Used to detect engine speed to indicate
vehicle is running.(Coil, Injector, cam/crank position sensors)
- Programmable Wait to Start Input. Detects 12v or
negative signals.(menu 3)
Description
This wire will test 0V in the OFF and START key
positions. 12-14V in the ACCESSORY key position.
Supplies 12votls for the IGNITION, PARK
LIGHT and SELECTABLE outputs.
Supplies 12 volts for ACCESSORY and
STARTER outputs.
Output for 2nd IGNITION, 2nd ACCESSORY
or 2nd STARTER.
Description
250ma ground output while remote starter
is activated.
REMOTE VEHICLE STARTER
is pressed and after
is pressed and before remote
or button for 3 secs