Auxiliary Connectors - Ultra Start 22 SERIES Install Manual

REMOTE VEHICLE STARTER

Auxiliary Connectors

11-Black
12-Blue
13-Blue/White Tach - A/C Tach Signal Input. Used to detect when the vehicle has
14-Pink
15-Wht/Violet GWR - (-) Output while remote starter is activated. Used to activate
3 Pin Connector Red
1-Green
2-Red
3-Blue
* The centre pin of the keyless entry harness is not to be used for anything besides
plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
4 Pin Connector Blue
RF Antenna/ Program Button Connector.
Remove the plastic from the adhesive tape and place the antenna in the center of the
windshield, behind the rear view mirror. Run the cable behind the head liner and
A-pillar panels to the module under the dash.
***The Antenna Must Be Connected Before the System will Operate.***
2 Pin Connector White
Connector for Instant Start Input or Temperature Sensor on LT models.
Note: This Input is not available on the 1250 Series.
3 Pin Connector White
1- White/Violet GWR - Ground output while running. This output can be used for
2- Black
3- Red
-
continued from previous page
Ground - System Chassis Ground Input.
Glow Plug - Diesel Glow plug input, detects both 12volt and negative
glow plug signals. Programmable input. See Menu 3.
started. This wire is connected to the vehicles coil, fuel injector or
crank sensor wire.
Brake input - Positive Brake Input. Used to detect the brake switch
being applied. Found at the brake switch connector.
Anti-theft bypass modules, adding 3rd ign etc.
Door Lock - Door Lock Output - Programmable Menu 1 Setting 3.
12volt Output - *Output For Door Lock Module Only!
Door Unlock - Door Unlock Output - Programmable Menu 1 Setting 3.
bypass module activation or adding additional relays.
Ground - Low current constant ground output.
12volts - Low current constant 12volt output.
INSTALLATION MANUAL
Page 9