Rossmax AC1000 f Instruction Manual
Hide thumbs
Also See for AC1000 f:
- Instruction manual (13 pages) ,
- User manual (19 pages) ,
- Manual (17 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Rossmax AC1000 f
Summary of Contents for Rossmax AC1000 f
- Page 1 Model: AC1000 f Instruction Manual www.rossmax.com...
-
Page 2: Table Of Contents
AC1000f is protected against manufacturing defects by an established International Warranty Program. For warranty information, you can con- tact the manufacturer, Rossmax International Ltd. Attention: Consult the accompanying documents. Please read this manual carefully before use. For specific information on your own blood pressure, contact your physician. -
Page 3: Cautionary Notes
If you have any problems, please contact the store or the doc- tor from whom you purchased this unit or please contact Rossmax International Ltd. 6. As a common issue for all blood pressure monitors using the oscillo-... -
Page 4: Notes On Safety
Notes on Safety Warning: • Self diagnosis of measured results or treatment is dangerous. Please follow the instruction of the doctor or healthcare pro- vider. • If cuff inflation does not stop, remove the cuff or pull out the air tube from the main unit. - Page 5 General advice: • Do not place or put anything on this unit. • Do not drop this unit. • Turn off power to the unit and unplug the AC adaptor from the electric outlet before moving the unit. • Read the instruction manual of the other devices to be used at the same time with this unit, to understand and be aware of the interaction between the devices.
-
Page 6: Name/Function Of Each Part
Name/Function of Each Part Charging LCD Display Arm Cuff START/ STOP key Battery Cover (Located on Air Tube and Memory/ back of unit) ON/OFF key Connector Marker key Deflation Rate Auto/Manual setting key Switching Key AC Adaptor Jack Data Link Socket Protection Jelly Battery Pack: 4.8V, 1700mAh... -
Page 7: Monitor Installation - Trolley (Optional)
Monitor Installation - Trolley (Optional) Placing Protection Jelly onto the Monitor Installing Monitor on the Trolley... -
Page 8: Real Fuzzy Measuring Technology
Real Fuzzy Measuring Technology This unit uses the oscillometric method to detect your blood pressure. Before the cuff starts inflating, the device will establish a baseline cuff pressure equivalent to the air pressure. This unit will determine the ap- propriate inflation level based on pressure oscillations, followed by cuff deflation. -
Page 9: Display Explanations
Display Explanations Display: Memory Mark Systolic Pressure Battery Mark AC Power Mark Diastolic Pressure Auto Mode Manual Mode Pulse Rate Set-Deflation Deflation Rate Mark... -
Page 10: Display Explanations
Display Explanations Icons: Measurement Error: Make sure the L-plug is securely con- nected to the air socket and measure again. Wrap the cuff cor- rectly and keep arm steady during measurement. If the error keeps occurring, return the device to your local distributor or service center. -
Page 11: How To Use The Power Source
Input: 100-240V~50/60Hz 0.8A Output: 7.5V 1.5A (Ø3.8 / Ø1.35) Brand: ROSSMAX Manufacurer: HON-KWANG • When using the battery pack and connect the AC adaptor, the unit also functions as the charger. Note: The AC adaptor can use with unit individually. (without battery... - Page 12 Warning: • Do not use this unit in places where inflammable gas, such as highly inflammable anesthetic, may be generated or in a high pressure oxygen room or an oxygen tent. It may cause ignition and explosion. • Do not touch the AC adaptor with wet hands. You may suffer electric shock.
- Page 13 1. Remove the screw on the battery cover (Located on back of unit) of this unit. 2. Installation: Connect the battery pack to the connector in the bat- tery cover to install it. Replacement: Disconnect the battery pack from the connector and replace with a new one.
-
Page 14: Low Battery
Battery life: • You can use the unit for approximately six hundred measurements with one charge. • Approximate life of battery pack is two years. However the battery pack life from each charging may be shortened depending on the state of using. Charging time: •... -
Page 15: Applying The Cuff
Applying the Cuff 1. Select cuff according to arm size: Rossmax Cuff size circumference 34~46 cm L size (13.4”~18.1”) 24~36 cm M size (9.4”~14.2”) 16~26 cm S size (6.3”~10.2”) 2. Connect the air tube securely. • Connect the air tube to the main unit by securing the air plug to the base of the air connector. - Page 16 3. Place the cuff over the bare up- per arm, wrap it with the tube pointing your palm, and the artery INDEX must mark over your main artery. be in OK range 4. The edge of the cuff should be at approximately 1.5 to 2.5 cm above the inner side of the elbow joint.
- Page 17 Manual Mode (with Stethoscope) Auto Mode (without Stethoscope) 7. This cuff is suitable for your use if the arrow falls within the solid color line. If the arrow falls outside the solid color line, you will need a cuff with other circumferences. Contact your local dealer for additional size cuffs.
-
Page 18: Measurement Procedures
Measurement Procedures Here are a few helpful tips to help you obtain more accurate readings: • Blood pressure changes with every heartbeat and is in constant fluc- tuation throughout the day. • Blood pressure recording can be affected by the position of the user, his or her physiological condition and other factors. -
Page 19: Setting Deflation Rate
This monitor will re-inflate automatically to approximately 220 mmHg if the system detects that your body needs more pressure to measure your blood pressure. 4. Manual Mode • Switching Auto mode to Manual mode by pressing the on the back of the unit. •... -
Page 20: Recalling Values From Memory
Recalling Values from Memory 1. Press the Memory key to view the last previously stored measure- ment. Every measurement comes with a assigned memory sequence number. 2. The memory bank can store up to 7 readings under Auto mode. The number of readings exceeds 7, the oldest data will be replaced with the new record. -
Page 21: Troubleshooting
Troubleshooting If any abnormality should arise during use, please check the following points. Symptoms Check Points Correction Have the batteries Replace them with four run down? new batteries. No display when the ON/OFF key is Have the batteries' Re-insert the batteries in pressed polarities been posi- the correct positions. -
Page 22: Specifications
Specifications Measurement Method : Oscillometric Measurement Range : Pressure: 30~260mmHg; Pulse: 40~199 beats/ minute Pressure Sensor : Semi conductor Accuracy : Pressure: ±3mmHg; Pulse : ±5% of reading Inflation : Pump Driven Deflation : Automatic Pressure Release Valve Memory capacity : 7 memories Auto-shut-off : 5 minute after last key operation... -
Page 23: Emc Guidance And Manufacturer's Declaration
EMC guidance and manufacturer’s declaration Guidance and manufacturer’s declaration-electromagnetic emissions The AC1000f is intended for use in the electromagnetic environment specified below. The customer or the user of the AC1000f should assure that it is used in such an environment. Emission test Compliance Electromagnetic environment-guidance... - Page 24 Opening or altering the instrument invalidates the guarantee. The guarantee does not cover damage, ac- cidents or non-compliance with the instruction manual. Please contact Rossmax Service. Rossmax Swiss GmbH, Tramstrasse 16, CH-9442 Berneck, Switzerland www.rossmax.com...
Need help?
Do you have a question about the AC1000 f and is the answer not in the manual?
Questions and answers