Fingerprint Reader Board (Select Products Only) - HP ENVY 17-n100 Maintenance And Service Manual

Reverse this procedure to install the TouchPad.

Fingerprint reader board (select products only)

Description
Fingerprint reader board
Fingerprint reader cable
Fingerprint reader bracket
Before removing the Fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the hard drive (see
8. Remove the speakers (see
9. Remove the system board (see
Remove the fingerprint reader board and cable:
1. Disconnect the ZIF connector cable (1) that secures the fingerprint reader to the top cover.
Battery on page 27).
Optical drive on page
Bottom cover on page
Hard drive on page 34).
Speakers (front) on page
System board on page
28).
31).
47).
49).
Component replacement procedures
Spare part number
818089-001
818088-001
818090-001
57