Table of Contents
Advertisement
3.
Disconnect the power connector cable from the system board (3), and then remove the power connector
and cable from the computer (4).
Reverse this procedure to install the power connector cable.
Fingerprint reader (select products only)
To remove the fingerprint reader, use this procedure and illustration.
Table 5-11
Fingerprint reader description and part number
Description
Fingerprint reader
Fingerprint reader cable
Before removing the fingerprint reader, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the fingerprint reader:
1.
Disconnect the cable from the ZIF connector on the system board (1).
2.
Remove the Phillips M2.0 × 2.0 screw (2) that secures the fingerprint reader bracket to the computer, and
then remove the bracket (3).
44
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page
31).
Spare part number
M45007-001
M45391-001
29).
29).
Advertisement
Table of Contents
