Installing A Pir Sensor; Pir Sensor Test Mode; Wireless Door/Window Magnetic Sensor; Door/Window Sensor (Front) - Response Electronics miGuard G5 Installation And Operating Instructions Manual

Installing a PIR Sensor

Avoid installing the Sensor directly facing a window, near air conditioning, heating, a
refrigerator, oven, in direct sunlight and places where the temperature fluctuates.
Also avoid placing two Sensors opposite each other; or within each others detection
range.
2.2m
Floor
Note: The ideal mounting height of the Sensor is 2.2 metres from the floor.
Mount the bracket using the screws supplied as shown in the figure on
the left. Then place the Sensor in the bracket. Position the PIR to cover
the required detection range. Test the operation of the PIR by putting it
into test mode, as described on page 36.
Side view
IMPORTANT: If the PIR Sensor is used in a room where pets are permitted fit the
Sensor vertical to the wall and do not tilt it downwards.
37

PIR Sensor Test Mode

1. Once the Sensor is fully installed and active it can be tested. Press the test button
once and walk from left to right or right to left in the room. The LED indicator will
flash once when motion is detected.
2. Adjust the angle of the Sensor if needed to obtain the best results.
3. Repeat step 1 and 2 to test the new angle.

Wireless Door/Window Magnetic Sensor

Door/Window Sensor (front)

Transmitter
Top view
0m 2m
110° 2m
0m
Top view
Side view
LED Status Indicator
Magnet
4m 6m 8m
38