Change Entry/Exit Delay Time; Setting Alarm Volume And Duration - Response Electronics miGuard G5 Installation And Operating Instructions Manual

Change entry/exit delay time

The system can be armed with a time delay. When a delay time is set you will hear a
beep every second as a warning of this delay. The beep will go faster in the last 15
seconds.(0-300 sec.):
Text '11' to the Control Panel.
11
Copy the message
Entry and exit delay time
(0-300 sec.):
30
After sending the message you will receive the following message from the Control Panel to
confirm the new settings:
Set delay time successfully.
25
adjust the time as example below
Entry and exit delay time
(0-300 sec.):
40

Setting alarm volume and duration

Both alarm volume and duration of the siren can be adjusted in this menu.
Text '12' to the Control Panel. Copy the message and adjust the volume ('0, 1 or 2') of the
siren and the duration of the siren as shown below.
12
Copy the message
Siren volume (0 Mute, 1 Low, 2 High):
2
Siren ringing time(1- 9min):
5
After sending the message you will receive the following message from the Control Panel to
confirm the new settings:
Set siren volume and ringing time successfully.
adjust the settings as example below.
Siren volume (0 Mute, 1 Low, 2 High):
0
Siren ringing time (1-9 min):
3
26