Change Disarm Password; Setting Single Zone Delay Time - Response Electronics miGuard G5 Installation And Operating Instructions Manual

Change disarm password

Text '13' to the Control Panel.
13
Copy the message
Disarm password(4-6 digits):
1234
After sending the message you will receive the following message from the Control
Panel to confirm the new settings:
Set disarm password successfully
27
enter your new password as example below
Disarm password(4-6 digits):
8888

Setting Single Zone delay time

Any Sensor can be set to 'Single Zone Delay'.
Text '14' to the Control Panel.
14
Copy the message:
Single zone delay time (0-300 sec.):
30
After sending the message you will receive the following message from the Control
Panel to confirm the new settings:
Set single zone delay time successfully
adjust the delay time as example below:
Single zone delay time (0-300 sec.):
15
28