IBM 6400 series Maintenance Manual page 382

Hide thumbs Also See for 6400 series:

Table of Contents

11. Remove the four 7/64 x 1/2 inch screws and washers securing the base

plate to the cabinet floor. (See Figure 62.)

12. Lower the elevator assembly to its lowest position.

13. Tilt the vertical rails toward the front of the printer until they clear the

upper frame cross-member. Slide the stacker assembly to rear and angle

it out of the cabinet, as shown in Figure 64.

Figure 64. Removing the Stacker Assembly

Cross-Member

Power Stacker

Chapters

Table of Contents