IBM 6400 series Maintenance Manual page 183

15. Press the Scroll key; "SELECT DOWNLOAD PORT=DATAPRODUCT"
appears on the LCD.
16. Press Scroll again to cycle through the download ports available in the
printer:
DATAPRODUCT
CENTRONICS*
RS232–9600
RS232–19.2K
RS232–38.4K
RS232–115K
RS422–9600
RS422–19.2K
RS422–38.4K
RS422–115K
17. Press Scroll + Scroll" to unlock the Enter key.
18. When the printer download port you want to use is displayed on the LCD,
press ENTER. "WAITING DOWNLOAD / PORT = < your selection >"
appears on the display.
19. At the DOS prompt on the computer type:
FILENAME.EXE –pb<return>
where FILENAME.EXE is the file you noted in step 12.
This command expands the file and copies it as a binary file into the flash
memory on the CMX controller board.
NOTE: If you are downloading the file using the LPT2 port on the PC, enter
20. While the file is copied into memory, the printer LCD informs you of the
load process and status. (See Table 5.)
21. When the file has successfully loaded into memory and the printer has
reset itself, set the printer power switch to O (off).
22. Unplug the AC power cord from the printer.
23. Remove the diskette from the personal computer and store it with the
printer.
Adjustment Procedures
(parallel)
(parallel) (default port)
(RS-232 serial, 9600 baud)
(RS-232 serial, 19200 baud)
(RS-232 serial, 38400 baud)
(RS-232 serial, 115000 baud)
(RS-422 serial, 9600 baud)
(RS-422 serial, 19200 baud)
(RS-422 serial, 38400 baud)
(RS-422 serial, 115000 baud)
the following DOS command:
FILENAME.EXE –pb 2 <Return>
If you are downloading the file into the printer serial port, enter the
following DOS commands:
MODE COM1:9600,N,8,1,P<Return>
FILENAME.EXE –PBC1<Return>
183