Table of Contents
Advertisement
Installing the first expansion blade
The examples in this procedure show the installation of the first performance module, adding new
blades to an existing X9730 cluster with two blades. Additional performance modules are installed
in the same manner. The following screen shows the cluster before the expansion blades are added.
To install the first blade in the expansion module, complete these steps:
1.
Log into the blade in the first expansion slot. The X9730 Setup dialog box is displayed.
2.
The setup wizard verifies the firmware on the system and notifies you if a firmware update is
needed. See
"Firmware updates" (page 72)
for more information.
Installing the first expansion blade
97
Advertisement
Table of Contents
Troubleshooting
