Table of Contents
Advertisement
4.
On the Change OA Network Properties screen, set Enclosure IP to Enable and press OK to
Accept.
5.
On the Network Settings: OA1 Active screen, select Accept All and press OK.
6.
On the Enclosure Settings screen, select Standby OA and press OK.
7.
On the Network Settings:OA2 screen, navigate to Active IPv4 and press OK.
8.
Set the IP address, subnet mask, and gateway (optional) and Accept the changes.
9.
On the Network Settings:OA2 screen, navigate to Accept All and press OK.
NOTE:
The following conditions can also make the install software unable to ping the OA:
VC is uplinked from X1 rather than X6 (be sure that X6 is used on X9730 systems)
A gateway is not defined for OA or blade
No L3 route from VC to OA
Duplicate IP is used for blade or OA
VC is already configured but blade 1 does not have a VC profile assigned
An X9370 blade boots, but the Installer cannot ping the VC
After the blade boots, the Installer reports that it cannot ping the VC and the ip addr command
reports only eth0 and eth1. Networks eth[2 7] are not visible. To correct this situation, complete
the following steps:
1.
Power off the blade.
2.
Log into the VC module from another system on the network.
Troubleshooting
75
Advertisement
Table of Contents
Troubleshooting
