HP IBRIX X9000 Installation Manual page 40

network details such as the IP address and hostname, relaunch the wizard, and try to set the
HA pair again.
If the operation still fails, use the following command to set the HA pair:
ibrix_server -b -h SERVERNAME1,SERVERNAME2
Network inconsistencies or an outage could cause the wizard to fail. Usually a network outage
lasts only a few minutes. Relaunch the wizard, go to the File Servers page, and click Next to
try to set HA pair again.
If the operation continues to fail, QR the system and retry the operation.
An HA backup server cannot be configured
Probable cause:
No storage was detected.
A backup candidate server was not listed.
Troubleshooting steps:
If the backup candidate server is not listed on the screen, restart the listener on that server
using service ibrix_discovery restart, relaunch the wizard, and go to the File
Servers page.
Run the ibrix_version
server. If the version does not match the version on the active server, update the X9000
software and QR the system again.
If the backup candidate server is listed but the Back-up not found error occurs, possibly
storage was not detected on either or both of the servers, or the storage was detected but it
did not match with the expected HA pair. If so, run the appropriate command on both servers:
X9730 systems: ccu show controllers all
X 9300/X9320 systems: multipath -ll
If the output matches on both servers, restart the discovery service:
service ibrix_discovery restart
Then relaunch the wizard and go to the File Servers page.
If the output does not match, the two servers are not considered to be an HA pair. Check the
storage settings and mapping to the controllers/servers.
If the HA pair detection fails after taking these actions, use the text-based installation method to
form the cluster.
A power source cannot be added
Probable cause:
The iLO IP address is not reachable.
The command timed out.
Troubleshooting steps:
Use the following command to determine whether the iLO can be accessed:
ping <iLO address>
If the iLO cannot be reached, use the route command to check the gateway used for the
server. Both the server and iLO should be on the same network. After verifying this, relaunch
the wizard and go to the File Servers page. Click Next to add the power source again.
If the operation still fails, use the following command to set the power source:
40 Configuring the cluster with the Getting Started Wizard (X9300/X9320 systems)
l command and check the X9000 software version on the backup