Table of Contents
Advertisement
4.
The Verify Configuration dialog box shows the configuration for the server. Select Commit to
continue.
5.
On the Form a Cluster — Step 2 dialog box, enter the cluster name and specify the IP address
and netmask for the Management Console IP (also called the Cluster Management IP). Also
enter the IP addresses and domain for your DNS servers, and the IP addresses for your NTP
servers.
6.
The Network Configuration dialog box lists the Ethernet devices included in bond0. The bond0
configuration is complete; select Continue and go to the next step.
NOTE:
If required, the configuration of bond0 can be modified at this step by selecting
bond0 in the list of devices and then selecting Configure. This should be necessary only if you
have a non-standard configuration and the slave devices chosen by the installer for bond0
are not correct for your environment.
Completing the installation in text mode — unified network
15
Advertisement
Table of Contents
Troubleshooting
