NEC VERSAPRO VG User Manual page 5

If you encounter problems during setup
The setup screen is not displayed
When [Press F2 to Enter BIOS Setup] is displayed on the screen when you turn the
power on, please carry out the following procedure.
1
Press the <F2> key.
The BIOS setup utility will then be displayed.
2
Use the number keys to enter the current hour (24 hour time format) and
then press <Enter>.
3
Use the <Tab>, <>, and <> keys to move to desired position and in the
same manner, set the rest of the time and date in the order of minutes,
seconds, month, day, and year.
4
Press the <F9> key.
The setup confirmation screen should come up.
5
Select [Yes] and then press <Enter>.
This will load the default factory setting values.
6
Press the <F10> key.
The setup confirmation screen should come up.
7
Select [Yes] and then press <Enter>.
The BIOS setup utility should now be finished and Windows will automatically restart.
After this, please refer to "Setup Procedure" (p.3) and continue on with the process.
If you accidentally turn off the power during setup
The setup process will not be successfully completed and Windows system files or
the registry may be corrupted.
In this case, either perform Windows recovery or consult your place of purchase.
The computer is unresponsive or shows an error message during setup
Make a note of the error message and hold down the power switch for at least four
seconds to perform a forced shutdown.
Please wait for at least five seconds before turning the power switch back on. After
that, please refer to the above "If you accidentally turn off the power during setup".
Using and configuring your computer after setup is complete
If the Windows license is not authenticated yet (Windows 8.1)
If the [Activate Windows] screen is displayed, activate the Windows system via the
Internet or by phone call.
<Activation via Internet>
1
Click [Go to PC settings].
When the computer is connected to the Internet, the Windows system is
activated automatically.
<Activation by phone call>
1
Click [Go to PC settings].
2
Click [Activate by phone].
Follow the on-screen instructions and call the indicated phone number to obtain
the confirmation ID.
Activate the Windows system using the confirmation ID.
Creating multiple SSD partitions
As a default setting, the first internal SSD has only one useable partition (volume),
designated as the C:drive.
However, it is possible to divide drive C: into multiple partitions.
Please refer to the following steps if you would like to change the factory default
settings and reduce the size of the C: drive in order to create a new partition from the
resulting unassigned space.
1
Click [Control Panel].
2
Click [System and Security] and then [Administrative Tools].
3
Double click [Computer Management].
4
On the tree displayed on the left side of the window, click [Storage]  [Disk
Management].
5
Select the volume marked as (C:) and right click it.
6
Click [Shrink Volume].
7
Enter the desired size into the [Enter the amount of space to shrink in MB] box.
The size entered here will become the maximum size of the newly created partition.
8
Click [Shrink].
9
After shrinking is complete, select the unassigned space that has been
reserved, and right click it.
10
Click [New Simple Volume].
11
Click [Next].
12
Enter the desired volume size into the [Simple volume size in MB] box and
click [Next].
13
Confirm that [Assign the following drive letter] is selected and click [Next].
14
Confirm that [Format this volume with the following settings] is selected
and click [Next].
5