Adjusting The Pressure Of Curl Eliminator Mechanism - Olivetti DF-670 Service Manual

3LB

(4) Adjusting the pressure of curl eliminator mechanism

Increase the pressure of the curl eliminator mechanism to reduce upward curling of paper stacked on the process table if
a paper jam occurs when batch ejection is performed because of strong upward curling.
Procedure
1. Remove the paper conveying unit from the
machine.
2. Loosen each two screws from the front and
rear curl eliminator pressure adjusting plates
respectively and then remove the plates.
3. Retighten each two screws.
4. Refit the all removed parts.
1-5-4
Screws
Curl eliminator
pressure
adjusting plate
Service Manual
Screws
Paper conveying unit
Figure 1-5-6
Curl eliminator
pressure
adjusting plate
Y108690-3