Table of Contents
Advertisement
Maintenance
item No.
Setting the limit for the ejection section of the built-in finisher
U236
Description
If the machine is equipped with an built-in finisher, this mode sets whether A5R/B5R/5
is output to the machine eject tray or not.
Purpose
If the machine is equipped with an built-in finisher and if paper jams occur due to curling of paper in the built-
in ejection section when two-sided copying onto A5R/B5R/5
used to change the setting to ON to disable ejection to the machine eject tray.
Setting
1. Press the start key.
2. Select ON or OFF.
Display
ON
OFF
Initial setting: OFF
3. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the finisher
U246
Description
Provides various settings for the built-in finisher, if furnished.
Purpose
Adjusts the side registration cursor stop position if paper registration is poor or stapling is made outside the
specified area.
Setting
1. Press the start key.
2. Press [FINISHER B-IN].
3. Select the desired cursor position.
4. Change the setting using the cursor up/down keys.
Display
FRONT
REAR
END
5. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Y108690-3
Description
Does not eject to the machine eject tray.
Eject to the machine eject tray.
Description
Front side registration cursor stop
position
Rear side registration cursor stop
position
Trailing edge registration cursor stop
position
Service Manual
Description
" x 8
" size paper is performed, this mode is
1/2
1/2
Setting
range
-4 to +4
-4 to +4
-4 to +4
" x 8
" size paper
1/2
1/2
Initial
Change in
setting
value per step
0
0.566 mm
0
0.566 mm
0
0.566 mm
3LB
1-3-7
Advertisement
Table of Contents
