Precor C842 Service Manual page 69

7. Replace the cover per Procedure 7.1.
8. Remove the right side cover.
9. Loosen but do not remove the locknut retaining the idler pulley. See Diagram 7.23. This will
remove tension from the primary belt.
Diagram 7.23 - Primary Drive Belt, C842, C842i, C846i and C846 version 2
Primary
Belt
Secondary
Axle
10. Remove the primary belt. Route the replacement primary belt around the primary pulley,
over the idler pulley and around the secondary axle as shown in Diagram 7.23.
11. Tension the primary belt per Procedure 5.1.
12. Replace the right side cover.
C842, C842i, C846, C846i Upright and Recumbent Cycle
Primary
Pulley
Pulley
Cover
Idler Pulley
Page 69