Precor C842 Service Manual page 71

10. Replace the cover per Procedure 7.1. This procedure is complete.
11. Remove the left side cover.
12. Loosen the jam nuts on the secondary belt tension adjustment bolt. Loosen the adjustment
bolt to remove tension from the secondary belt. See Diagram 7.25. remove the secondary
belt.
Diagram 7.25 - Secondary Drive Belt, C842, C842i, C846i and C846 version 2
Secondary
Pulley
Adjustment
Bolt
13. Route the replacement secondary belt over the secondary pulley and generator pulley as
shown in Diagram 7.25.
14. Tension the secondary belt per Procedure 5.2.
15. Replace the left side cover.
C842, C842i, C846, C846i Upright and Recumbent Cycle
Secondary
Belt
Generator
Pulley
Jam Nuts
Page 71