Final Check - York Fitness YBR-PXT-220 Owner's Manual

Final Check

Your equipment is now assembled. Please make the following
final checks:
• Make sure all screws / bolts are tightened.
• Make sure the equipment is on a flat, level surface.
Self-Generate Resistance
This exercise equipment uses a self-generate resistance and
will recharge the battery through pedalling.
• Start pedalling to turn on the console.
• The computer will turn off automatically after few seconds
of inactivity
BATTERIES REPLACEMENT
INSTRUCTIONS:
WARNING: The cross trainer use NiMH batteries. Using
other types of batteries during charging will damage the
equipment. DO NOT USE ALKALINE BATTERIES IN THIS
PRODUCT.
1. Open the battery compartment under the cross trainer.
2. Remove batteries.
3. Insert 5 AA batteries ensuring you match the polarity
markings (+ and -) on the batteries with the indicators in
the battery compartment. Push flat end ( - ) against spring
and when clear push other end into holder.
4. Close the battery compartment.
Tips & Warnings
• Always change all the batteries at the same time.
• Always use the same type of batteries.
• Never recharge Alkaline AA batteries.
• Do not try to heat, ignite, disassemble or throw AA
batteries into a fire.
• Do not leave old batteries in the console, and remove
batteries from the console if you won't be using it for a
long time.
Protect the environment by not disposing
of this product or batteries with household
waste. Check your local authority for recycling
advice and facilities.
* PICTURE MAY VARY FROM ACTUAL MODEL.
www.yorkfitness.com
YB R- PX
T-2 20
13