Jenn-Air W156 Use And Care Manual page 7

Clock Controls
When electrical power is supplied or after power interruption, the last clock time
displayed before power was interrupted will flash. Time will advance and continue
to flash until clock is reset.
To set time of day:
1. Touch Clock Pad.
Indicator word TIME will flash and AM or PM and time digits will appear in
the Display. (If more than 10 seconds elapse between touching Clock Pad and
turning the Set Dial, the Clock Pad must be touched again in order to set clock.)
2. Turn Set Dial in either direction until correct time of day appears in Display.
NOTE: Three seconds after turning dial, time of day will automatically be entered.
Once the time is set, the AM or PM indicators will not show unless the
Clock Pad is touched.
To recall time of day when another time function is showing: Touch Clock Pad.
(Note: AM or PM will not remain in the Display.)
To change time of day set on clock: Repeat above sequence.
NOTE: Clock time cannot be changed when oven has been programmed for
Timed Bake, Timed Convect or Self-clean. Cancel program before
reprogramming clock.