Jenn-Air W156 Use And Care Manual page 21

PROBE
(Models W156 and W256 Upper Oven) ....
BASIC INSTRUCTIONS
1. Insert probe.
2. Touch Probe Pad.
3. Turn Set Dial to desired temperature.
4. Touch Bake Pad or Convect Bake Pad.
5. Turn Set Dial to desired temperature.
6. Touch Cook Time Pad.*
7. Turn Set Dial to enter estimated cooking time.*
8. Touch Stop Time Pad.*
9. Turn Set Dial to enter Stop Time.*
*Omit steps 6-9 if you wish to start cooking immediately.
To set probe feature:
1. Insert the probe into the food item. For
meats, the probe tip should be located
in the center of the thickest part of the
meat and not in fat or touching a bone.
2. Place the food in the oven using the rack
position suggested on page 11.
3. Insert the probe plug into the receptacle
located behind the metal cover plate on
the right inside oven wall. Be certain to
insert plug into the receptacle all the way.
NOTE: After the probe is inserted, the Indicator Word PRB will flash and signal
will beep reminding you to enter the desired probe temperature. _
4. Touch Probe Pad.
Indicator Word PRB will flash and three dashes will be shown in the Display.
5. Turn Set Dial to desired degree of doneness.
The Set Dial must be turned clockwise one click. 135° will be shown. Then the
Set Dial can be turned in either direction. If desired, the temperature may be
set upward or downward in 5 ° increments.
(Allowable range is 100° to 200°.)
EXAMPLE: At 10 o'clock to set the probe for 150 °, turn Set Dial clockwise until
Display shows:
I i'-I "i--l i--I ! 15 D°
Lt. !_tU
22