Adjusting The Throttle Position Sensor (For Throttle Cable Pulley) - Yamaha YZF-R1 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Temporary tighten the throttle position sen-
sor (for throttle valves).
b. Check that the throttle valves are fully
closed.
c. Connect the throttle position sensor (for
throttle valves), throttle position sensor (for
throttle cable pulley) and throttle servo
motor to the wire harness.
d. Turn the main switch to "OFF" and set the
engine stop switch to "ON".
e. Simultaneously press and hold the
"SELECT" and "RESET" buttons, turn the
main switch to "ON", and continue to press
the buttons for 8 seconds more.
NOTE:
"dIAG" appears on the odometer, tripmeter and
fuel reserve trip LCD.
f. Diagnostic code 01 is selected.
g. Adjust the position of the throttle position
sensor angle so that 16 can appear in the
meter.
h. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws "1".
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS4C81023
ADJUSTING THE THROTTLE POSITION
SENSOR (FOR THROTTLE CABLE PUL-
LEY)
1. Check:
email: info@motomatrix.co.uk
THROTTLE BODIES
• Throttle position sensor (for throttle cable
pulley)
Refer to "ADJUSTING THE THROTTLE
POSITION SENSOR (FOR THROTTLE
CABLE PULLEY)" on page 7-7.
2. Adjust:
• Throttle position sensor (for throttle cable
pulley) angle
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Temporary tighten the throttle position sen-
sor (for throttle cable pulley).
b. Check that the throttle valves are fully
closed.
c. Connect the throttle position sensor (for
throttle valves), throttle position sensor (for
throttle cable pulley) and throttle servo
motor to the wire harness.
d. Turn the main switch to "OFF" and set the
engine stop switch to "ON".
e. Simultaneously press and hold the
"SELECT" and "RESET" buttons, turn the
main switch to "ON", and continue to press
the buttons for 8 seconds more.
NOTE:
"dIAG" appears on the odometer, tripmeter and
fuel reserve trip LCD.
f. Diagnostic code 14 is selected.
g. Adjust the position of the throttle position
sensor angle so that 17 can appear in the
meter.
h. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws "1".
7-7