Assembling The Rear Brake Master Cylinder; Installing The Rear Brake Master Cylinder - Yamaha YZF-R1 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
4. Check:
• Brake hoses "1"
Cracks/damage/wear → Replace.
EAS22730
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
EWA13520
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake
components.
Recommended fluid
DOT 4
1. Instal:
• Brake master cylinder kit
EAS22740
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• Copper washers
• Brake hoses
• Union bolt
Rear brake hose union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
email: info@motomatrix.co.uk
New
New
EWA13530
WARNING
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING" on page 2-39.
ECA14160
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection "a" as shown.
2. Fill:
• Brake fluid reservoir
(to the maximum level mark "b")
Recommended fluid
DOT 4
EWA13090
WARNING
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing brake
fluids may result in a harmful chemical
reaction, leading to poor brake perfor-
mance.
4-43
REAR BRAKE