Olivetti d-COPIA 3013MFplus Operation Manual page 395

Symptom
Printouts are dirty.
Printouts are fuzzy.
Images are skewed.
Cannot feed originals.
Paper often jams.
Printouts are wrinkled
or curled.
Cannot print.
Documents are
printed improperly.
Check Points
Is the platen or the document
processor dirty?
Is the machine being used in
very humid conditions?
Are the originals placed
correctly?
Is the paper loaded
correctly?
Are the originals placed
correctly?
Is the paper loaded
correctly?
Is the paper of the supported
type? Is it in good condition?
Is the paper curled, folded or
wrinkled?
Are there any loose scraps or
jammed paper in the
machine?
Is the paper damp?
Is the machine plugged in?
Is the machine powered on?
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
Is the print job paused?
Is the error message
displayed?
Are the application software
settings at the PC set
properly?
10-3
Corrective Actions
Clean the platen or the document
processor.
Use in a location that has suitable
humidity.
When placing originals on the
platen, align them with the slit
glass.
When placing originals in the
document processor, align the
original width guides securely
before placing the originals.
Check the position of the paper
width guides.
When placing originals in the
document processor, align the
original width guides securely
before placing the originals.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Replace the paper with new paper.
Plug the power cord into an AC
outlet.
Turn on the power switch.
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Press [Resume] (the Left Select
key) to resume printing.
Follow the corresponding
procedure.
Check that the printing system
driver and application software
settings are set properly.
Troubleshooting
Reference
Page
9-2
—
2-59
2-60
2-60
2-60
2-46
2-46
10
2-46
10-13
2-46
—
2-6
2-5
2-5
2-6
7-19
10-6
—