GREAT PLANES P-40 Warhawk Instruction Manual page 16

use a 3mm tap and drill set to create threads in the four mounting
holes. Attach the engine to the mount using four 3mm x 20mm
SHCS, four 3mm lock washers, and four 3mm fl at washers.
❏
9. Install the throttle servo into the throttle servo bay with
the servo splines facing the same side of the plane as the
throttle arm on the engine.
❏
10. Cut two 1-1/2" [38mm] pieces from the included 6mm
x 6mm stick. Glue them to the fuse stringers fl ush with the
bottoms approximately 1" [25mm] behind the stick holding
the fuel tank in place.
❏
11. Prepare the radio installation by locating the glow
engine receiver tray, two rubber bands, receiver, and
receiver battery. You will also need some 1/4" [6mm] or 1/2"
[13mm] foam rubber (not included). Cut a piece of foam
rubber that fi ts your receiver battery pack and sandwich
it between the pack and the receiver tray. With the pack
centered on the top of the receiver tray (receiver tray shown
upside-down), use a rubber band looped onto the tray tabs
to strap the pack in place as shown.
❏
12. Fit the receiver tray onto the 6mm x 6mm sticks you
glued in step 10. Drill a 5/64" [2mm] hole at each end of the
receiver tray into the sticks. Attach the tray to the sticks using
two 2.5mm x 10mm self-tapping screws. Cut another piece
of foam rubber to fi t your receiver. Secure the receiver to
the tray with the foam rubber between them using the other
rubber band.
16