Install The Engine; Install The Landing Gear - GREAT PLANES Ju-87 Stuka Instruction Manual

INSTALL THE ENGINE

1. Locate the left and right halves of the engine mount.
Cut off the "spreader bar" from each half of the engine mount.
2. Install the engine mount to the firewall. Screw four 8-32
x 1" socket head cap screws and four #8 washers through
the engine mount into the pre-installed 8-32 blind nuts in the
firewall.
3. Adjust the width of the engine mount for your engine.
Then position the engine onto the engine mount so that the
distance from the firewall to the front of the thrust washer is
4-3/4" [121mm].
4. Once you have the engine properly positioned on the
engine mount, mark the location of the engine mounting
holes on the rails of the engine mount. A great tool for doing
this is the Great Planes Dead Center
fast, easy and accurate!
5. Once you have the locations for the mounting holes
marked on the engine mount, drill a 7/64" [2.8mm] hole into
each of the four marks. After drilling the holes tap each of
them with a 6-32 tap.
6. Mount the engine to the engine mount with four 6-32 x
3/4" socket head cap screws and four #6 washers.

INSTALL THE LANDING GEAR

1. Locate the left and right landing gear. Test fit the
right landing gear wire into the slots in the right wing.
16
™ Tool (GPMR8130). It's