Wing Assembly - GREAT PLANES Ju-87 Stuka Instruction Manual

WING ASSEMBLY

1. Locate the two plywood center wing joiners and four
plywood outer wing joiners. Using 6-minute epoxy, glue
two plywood center wing joiners together forming one 1/4"
[6mm] center wing joiner. Do the same to the outer wing
joiners, making two 1/4" [6mm] outer wing joiners.
2. Locate the right wing panel and the right inner
wing panel. At the root of each wing panel where the two
panels join are two strings. Tie the strings together. The
strings will be used for pulling the servo wires through the
wing when the radio installation takes place.
3. Test fit the outer wing joiner to the wing panel and
the inner wing panel. Be sure the wing panel is assembled
to the correct end of the inner wing panel. The end of the
inner wing panel without the cut-out is the end of the panel
that is glued to the wing panel. Be sure when fitting the joiner
that the bend in the wing is going the proper direction (see
photo). When you are satisfied that everything fits properly,
use 30-minute epoxy to join the two wing sections and glue
the joiner into the wing box in the wings (Be sure to use
6