Troubleshooting Guide - Hyundai RT 910 Instruction Manual

TURNTABLE OPERATION
1. Turn the unit on by pressing the POWER SWITCH (6) at the side of the unit, to the "O"
position. The power indicator (5) at the front of the unit will light up.
2. Turn the FUNCTION SWITCH (2) to PHONO mode.
3. Move the SPEED CONTROL SWITCH (11) to the desired speed, select from 33, 45 or 78
rpm. Place the record on the turntable (8).
4. Adjust the VOLUME CONTROL (4) and set this at mid range.
5. Use a finger to raise the tone arm (10) off its rest. Move the tone arm over the record and
gently release the tone arm to the point where you want to play the record.
6. Adjust the VOLUME CONTROL CNOB (4) to your desired sound level.
7. At the end of the record, the TONE ARM (10) will stop automatically at the centre. The
TONE ARM (10) has to be returned manually to the ARM REST (12).
RADIO OPERATION
1. Turn the unit on by pressing the POWER SWITCH (6) at the side of the unit, to the "O"
position. The power indicator (5) at the front of the unit will light up.
2. Turn the FUNCTION SWITCH (2) to select either AM or FM frequency position.
3. Turn the TUNING KNOB (12) to select your desired position.
4. Adjust the VOLUM CONTROL KNOB (4) to your desired sound level.
5. Turn the unit off bypressing the POWER SWITCH (6) at the side of the unit, to the "I"
position.
LINE-OUT JACK OPERATION
1. Connect the RCA Line-out Jack (14/15) into the external amplifier to play the music from
outside source.
LINE IN
1. Turn the unit on by pressing the power switch (6) conect the music source you want to play
with Line-in jack (13), then you can use the unit to play the connect music source.
ACCESSORy: ADAPTER fOR 45 RPM
To play a 45 rpm record, place the supplied adaptor (9) on the SPINDLE (7)

TROUBLEShOOTING GUIDE

The unit will not operate.
• Check that the unit is properly connected to an A/C power outlet.
No sound is coming from the unit
• Check that the ON/OFF VOLUME KNOB (4) and see the volume level..
• The white protective needle cover has not been removed from the tone arm.
The tone arm will not move
• Remove black tie wrap from the tone arm.
• The tone arm hold down clip has not been released.
No Radio
• The FUNCTION SWITCH (13) has not been moved from the PHONO
position.
• Adjust the ON/OFF VOLUME KNOB (4) and see the volume level.
• Rotate the TUNING KNOB (3) to find the desired radio station.
EN - 23
EN