Power Source; Unpacking The Turntable - Hyundai RT 910 Instruction Manual

15. Power Lines - An outside antenna system should not be located in the vicinity of overhead
power lines or other electric light or power circuits, or where it can fall intosuch power lines
or circuits. When installing an outside antenna system, extreme care should be taken to
keep from touching such power lines or circuits as contact with them might be fatal.
16. Overloading - Do not overload wall outlets, extension cords,or integral convenience
receptacles as this can result in a risk of fire or electric shock.
17. Object and Liquid Entry - Never push objects of any kind into this product through openings
as they may touch dangerous voltage points or short-out parts that could result in a fire or
electric shock. Never spill liquid of any kind onthe product.
18. Servicing - Do not attempt to service this product yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to qualified
service personnel.
19. Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
a. When the power supply cord or plug is damaged,
b If liquid has been spilled, or objects have fallen into the product,
c If the product has been exposed to rain or water,
d If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions as an improper
adjustment of other controls may result in damage and will often require extensive work
by a qualified technician to restore the product to its normal operation.
e If the product has been dropped or damage in any way, and
f When the product exhibits a distinct change in performance - this indicates a need for
service.
20. Replacement Parts - When replacement parts are required, be sure the service technician
has used replacement parts specified by the manufacturer or have the same characteris-
tics as the original part. Unauthorized substitutions may resultnfire,electric shock, or other
hazards.
21. Safety Check - Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to determine thatthe product is in proper operating
condition.
22. Heat - The product should be situated away from heat sources such as radiators, heat
register, stoves, or other products (including amplifiers) that produce heat.

POwER SOURCE

1. Unwind the AC POWER CORD (16) at the back of the unit and connect it to a power outlet.
2. Plug A/C cord into appropriate outlet.

UNPACKING ThE TURNTABLE

1. Carefully remove unit from it's package and take it out of the plastic bag.
2. Open lid and remove black tie-wrap by untwisting and gently sliding out from under TONE
ARM (10).
3. Remove white protective needle cover by gently pulling towards front of unit.
EN - 22