NEC SL1100 Installation Instructions Manual page 24

11.
You'll automatically be entered into Programming Mode 10-12-03 where you will be asked to enter your
Default Gateway. Refer to the number you wrote down in Part 1, and type your Default Gateway IP
Address.
12.
Press the Menu Key multiple times until you reach Programming 10-12-09.
13.
At 10-12-09 you'll be asked to enter the IP Address of the VoIP Card. Refer to the number you wrote
down in Part 1, and type your VoIP Card IP Address.
14.
Press the Mute Key Four Times to back out of 10-12 programming.
15.
Using the dial pad, type 84-26-01. Press 0 for the Slot Number. The IP Address on this screen will be
used for Voice Ports. Refer to the number you wrote down in Part 1, and type your Voice Ports IP
Address, then Press the Menu Key.
16.
Press the Mute Key Four Times to back out of programming.
17.
Press the Exit Key.
GIVE THE PHONE SYSTEM 5 MINUTES TO SAVE CHANGES
Even though the phone's display has come back up, the changes are still
being written to the processor! Do NOT reboot the system during this time.
Also, IF this is a pre-existing phone system and it already has custom
programming, we strongly recommend backing up the phone system's
database before continuing.
18.
After 5 Minutes, Power off the Phone System.
19.
Plug in your Ethernet Cable to the VoIP Ethernet Port on the VoIP Card. (For a diagram of the
SL1100's Ethernet Ports, see the next page)
1-888-632-3794 • info@necsl1100distributors.com
SL1100 Installation Instructions
5