Typical Operation Sequence - Lang GCOF-PPNATFD Installation, Operation, Maintenance And Service Instructions

TYPICAL OPERATION SEQUENCE

ACTION
Turn power switch to ON.
Press a product button.
Beeper sounds briefly.
Open the oven doors and load the product.
Close the door and press the product
button again.
Press the shelf button(s) which correspond
to the shelf positions, which the product is
loaded (A equals the top shelf and E
equals the bottom shelf).
Beeper sounds continuously.
Press the flashing shelf button(s).
Open oven door and remove the product,
which corresponds to flashing shelf
button(s).
UL File# MH19366
RESULT
Control panel comes on, display says
"SELECT PRODUCT OR READ/CLEAR
TO PROGRAM.
Display says "PRODUCT X PREHEATING
TO XXX F". Motor starts and oven begins
preheating to the programmed
temperature.
Display says "READY SELECT
PRODUCT TO START ".
Beeper sounds briefly and display says
"SELECT OVEN SHELVES PRODUCT
X".
Display shows a countdown timer and
begins to count toward zero.
Display shows "DONE PRESS SHELF
BUTTON X, REMOVE PRODUCT", shelf
button(s) flash.
Beeper stops. Display shows "READY
SELECT PRODUCT TO START" if no
other shelves carry product or resume
count down for shelves that still have
product cooking.
15
Operation cont'd