Install The Propeller And Motor Battery; Install The Wing On The Fuselage - Hobbico Superstar EP Assembly Instructions Manual

Install the Propeller and Motor Battery

❏ 1. Slide the aluminum prop adapter over the
motor shaft. Slide the aluminum prop adapter
retainer over the prop adapter. Note: The hole
through the prop adapter retainer is beveled. The
side with the larger hole goes on first.
❏ 2. Slide the propeller onto the prop adapter. The
front of the prop has 9 x 5.5 lettering molded into it.
Secure the propeller to the prop adapter with the
aluminum prop washer and prop nut. Hold the prop
adapter retainer while tightening the prop nut. Make
sure the prop is securely attached to the motor shaft.
❏ 3. Insert the motor battery in the battery
compartment. Secure the battery with a hook and
loop strap. It is not necessary to plug the motor
battery into the electronic speed control until you
are ready to fly.
❏ 4. Insert the lip on the battery hatch under the
sheeting at the aft end of the battery compartment.
Lock the battery hatch in position by rotating the
battery hatch retainer over the battery hatch.

Install the Wing on the Fuselage

❏ 1. Center the wing on the fuselage. Place a
rubberband around the aft wing hold-down dowel
and stretch it over the top of the wing, placing it
around the forward wing hold-down dowel. Attach a
second rubberband on the other side of the fuselage.
❏ 2. Again place a rubberband around the aft wing
hold-down dowel and stretch it over the top of the
wing, this time crossing over to the other side of the
fuselage before placing it around the forward wing
hold-down dowel.
❏ 3. Repeat the process to install the four
remaining rubber bands.
16