Table of Contents
Advertisement
!
WARNING:
cord clear of the work area. Position the
cord so that it will not get caught on the
workpiece, a tool, or any other obstruction
while the power tool is in use.
If an extension cord is used with this multi-
nailer, verify that it is in good condition.
When using an extension cord, be sure to
use one that is heavy enough to carry the
current that the tool will draw. An
undersized cord will cause a drop in line
voltage, which will result in a loss of power
and cause overheating of the tool.
The following table shows the correct size
to use according to cord length and the
amperage rating that is listed on the tool's
nameplate. When in doubt, use the next
heavier gauge. The smaller the gauge
number, the heavier the cord.
Verify that the extension cord is properly
wired and in good condition. Replace a
damaged extension cord immediately, or
have it repaired by a qualified electrician
before using it. Keep the extension cord
away from sharp objects, excessive heat,
and damp or wet areas.
Use a separate electrical circuit for power
tools. This circuit must consist of not less
than 14-gauge wire, and should be
protected by either a 15 A time-delayed
fuse or a circuit breaker. Before connecting
the power tool to the outlet, verify that the
switch is in the OFF position, and that the
voltage of the power source is the same as
the voltage that is indicated on the tool's
nameplate. Running this multi-nailer at a
lower voltage will damage the motor.
EXTENSION CORD SAFETY
Keep the extension
MINIMUM GAUGE (AWG) EXTENSION
(120 V use only)
Ampere Rating
Not
More
More
Than
Than
0
6
6
10
10
12
12
16
8
CORDS
Total length in feet
25'
50'
100'
18
16
16
18
16
14
16
16
14
14
12
Not Applicable
150'
14
12
12
Hide quick links:
Advertisement
Table of Contents
