Assembly; Wheel Kit Assembly - Westinghouse WHXC3750 Instruction Manual

WHEEl Kit assEMBlY

before assembling the generator,
review Safety on page 7 and the
following safety messages.
!
Never lift the generator without
assistance. The generator is heavy
and lifting without assistance could
result in personal injury.
Never use the handles as a lifting
!
point to support the entire weight of
the generator. Only use the handles to
lift one end of the generator and then
move it around on its wheels.
Use caution when collapsing the
handles. Hands or fingers could get
caught and pinched.
NOTICE
Assembling the generator will require lifting the unit
on one side. Make sure all engine oil and fuel are
drained from the unit prior to assembling.
Once assembled, the wheel kit is not intended for
towing the generator either on or off-road. The
wheel kit is designed for use on this generator only.
Tools required (not included) – 10 mm spanner
(qty 2) and 13 mm spanner (qty 2).
CAUTION

ASSEMBLY

1. Place generator on a flat surface.
2. Place a piece of cardboard or other soft material
to tip the generator onto, to protect the frame paint
and prevent the generator from sliding. Tip the
generator onto its side as shown in Figure 4 with
the engine at the bottom.
3. Attach the rubber pads onto the mounting foot
using the M6 bolts and nuts as shown in Figure 5.
Figure 4 - Tip the Generator onto its Side
13