Westinghouse WHXC3750 Instruction Manual page 14

ASSEMBLY
4. Attach the mounting foot to the frame using the
M8 bolts and nuts.
C
b
Figure 5 – Attaching Mounting Foot to Frame
A - Rubber Pads
b - Mounting Foot
5. Insert an axle through one of the wheels from the
recessed hub side. Then insert the protruding axle
through one of the axle brackets on the frame
beside the engine.
6. Insert the straight leg of one cotter pin through the
hole in the end of the axle.
A
Figure 6 – Attaching Wheel to Frame
A - Axle
14
5 A
C - M8 Flange Bolt
and Nut
b
b - Cotter Pin
7. Repeat steps 5 and 6 using the other axle, wheel
and cotter pin.
8. Install each handle using a clevis pin and cotter
pin as shown in Figure 7.
A
C
b
Figure 7 – Attaching Handle to Frame
A - Clevis Pin
b - Handle
C
C - Cotter Pin