A2.2 Configuration - Avtech DG1015 User Manual

A2.2 Configuration

Before configuring Push Video, make sure:
1. The DVR system is set up as described in "2. CONNECTION AND SETUP" at page 4.
2. The DVR is connected to Internet.
3. You've installed the app, EagleEyes, on your iOS or Android mobile devices.
For details, please refer to "
Step1: Right click to show the main menu.
(ADVANCED CONFIG.)  "NOTIFY". In PUSH VIDEO, select the alarm device you want, and
Go to
configure the alarm type. For details, please refer to "PUSH VIDEO" at page 43.
CANERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DCCS
NOTIFY
MULTICASTING
EXIT
Step2: Open EagleEyes, and add this DVR to the EagleEyes address book.
Step3: Enable Push Video as described below, and try to trigger your sensor to see if you can receive Push Video
successfully.
7.2 Mobile Devices
ADVANCED CONFIG
PUSH VIDEO PUSH STATUS
RESET ALL GUARD CONNECTION
ALARM TRIGGERED DEVICE
CH01 ALARM OFF / INTERNAL ALARM
CH02 ALARM OFF
CH03 ALARM N.O.
CH04 ALARM OFF
" at page 53.
MESSAGE MAIL VIDEO MAIL




62
APPENDIX 2 PUSH VIDEO CONFIGURATION
VIDEO FTP
SUBMIT

ALARM IN 1
CH1
CH2
office
CH4