Dccs; Ivs - Avtech DG1015 User Manual

4) RATE
Select the baud rate for the connected PTZ camera (2400 / 4800 / 9600 / 19200 / 38400 / 57600 / 115200).
Make sure the baud rate setting of the camera is the same as the setting here, or the DVR will not be able to
control the device.
Note: To know the default baud rate of the PTZ camera, please refer to its user manual.

6.4.8 DCCS

This function is used for our brand's HD CCTV camera series. Users could access the setup menu of the camera
itself for further configurations.
CAMERA CH1 CH2 CH3 CH4
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS

IVS

NOTIFY
EXIT
1) DIAGNOSTIC
When our brand's HD CCTV camera is connected, click "START" to ensure the DVR recognizes it. This
function disappears when the DVR recognizes the camera properly.
2) MENU
Click "SETUP" to enter the camera's configuration page.
6.4.9 IVS
Note: This function is for selected models only.
Note: Before using the IVS function, make sure the event record function is enabled on your DVR.
IVS, Intelligent Video Surveillance, is the advanced application for motion detection, but more precise and smarter.
It can be applied to different situations with one of the following three modes: FLOW COUNTING, VIRTUAL
FENCE, and ONE WAY.
When anyone crosses the detection line (virtual fence), the recording will be on.
Note: Four camera channels are supported for this function.
CAMERA IVS1 IVS2 IVS3 IVS4
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT
1) CAMERA
Select the camera channel that you want to use the IVS function.
ADVANCED CONFIG
DIAGNOSTIC
MENU
DEVICE
CONNECTION
ADVANCED CONFIG
CAMERA
IVS MODE
DISPLAY LINE
SENSITIVITY
RESET COUNT
VIRTUAL FENCE AREA
SCENE CHANGE
SCENE CHANGE LEVEL
START
SETUP
CAMERA
UNKNOWN
CH3
FLOW COUNTING
OFF
7
SUBMIT
SETUP
OFF
MIDDLE
39





MAIN MENU