Instruction
To set the clock
1. Press "CLOCK button".
2. Press "TIMER setting button" to set the
3. Press "CLOCK button".
Turn the breaker ON
•
NOTE
Tips for saving energy
•
Be careful not to cool (heat) the room too much.Keeping the temperature setting at a
moderate level helps save energy.
•
Cover windows with a blind or a curtain.Blocking sunlight and air from outdoors
increases the cooling (heating) effect.
•
Clogged air filters cause inefficient operation and waste energy. Clean them once in about every two weeks.
Please note
•
The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
•
If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
•
Use the air conditioner in the following conditions.
Mode
COOL
HEAT
DRY
•
Operation outside this humidity or temperature range may cause a safety device to disable the system.
82
0:00 is displayed.
blinks.
clock to the present time.
Holding down "
" or "
increases or decreases the time display.
: blinks.
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
Operating conditions
Outdoor temperature: [2MK(X)S] 10 to 46°C
[3/4MK(X)S] –10 to 46°C
[RK(X)S] –10 to 46°C
[RK(X)H] 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
Outdoor temperature: [2MXS] –10 to 21°C
[3/4MXS] –15 to 21°C
[RXS] –15 to 21°C
[RXH] –10 to 21°C
Indoor temperature: 10 to 30°C
Outdoor temperature: [2MK(X)S] 10 to 46°C
[3/4MK(X)S] –10 to 46°C
˛
[RK(X)S] –10 to 46°C
˛
[RK(X)H] 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
" button rapidly
If operation is continued out of this range
• A safety device may work to stop the
operation.(In multi system, it may work to stop
the operation of the outdoor unit only.)
• Condensation may occur on the indoor unit and
drip.
• A safety device may work to stop the operation.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and
drip.
SiENBE04-401A
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE
FAN
SWING
SILENT
SENSOR
ON
CANCEL
OFF
TIMER
Recommended temperature setting
For cooling:26°C – 28°C
For heating:20°C – 24°C
System Configuration
2
1.3