Samsung SCX-8030ND Series Service Manual page 345

● Code :
M2-2213
M2-2215
M2-2216
● Symptom / Cause :
-The paper has not reached the duplex jam 2 sensor w
sensor.
- When opening and closing the side door, the paper j
● Troubleshooting method :
1. Open the side door. Remove the jammed paper.
Close the side door. After warm up, if same jam occ
2. If there is any obstacles on duplex path, remove it.
3. If the feed roller is broken away, reassemble it.
4. Make the duplex 2 jam sensor be pushed by pushin
Close the side door.
Enter the diagnostic mode, and execute the duplex 2
Be the paper at sensor. If "Without paper" message
5. Check if the Joint PBA connector is connected prop 5 Ch k if th J i t PBA
or replace the Joint PBA.
● Replacement part
- JC92-02233A : SIDE JOINT JC92 02233A : SIDE JOINT
Service Manual
SCX-8030/8040 series
7.Troubles shooting
● Error message :
Paper jam at the insi ide of duplex path.
within a regular time after passing the duplex jam 1
am has occurred at duplex jam 2 sensor.
curs, check the following.
y
g duplex gate and pulling down the timing belt.
2 jam sensor test.
is displayed, replace the sensor or the actuator.
t i t d erly. If there is any problem, reconnect the connector
7-5 52
l If th i bl t th t
SAMSUNG ELECTRONICS
Version 0.05